User's Manual

17. Document History
R
R
e
e
v
v
i
i
s
s
i
i
o
o
n
n
D
D
a
a
t
t
e
e
C
C
h
h
a
a
n
n
g
g
e
e
s
s
ISSUE#0
2009-01-26
First ISSUE# 0 - DRAFT
ISSUE#1
2009-02-15
Updated current consumptions table
ISSUE#2
2009-02-15
Updated Pinout description
ISSUE#3
2009-03-18
Updated mechanical dimensions (balls spacing),
charger description removed,
Added better explanation of pin H5 (RF) and H1 (service)
ISSUE#4
2009-04-02
Updated VBATT supply Range, DAC schematic, Conformity assessment
ISSUE#5
03/06/2009
Updated section 13 (FCC Conformity assessment)
ISSUE#6
04/06/2009
Updated section 13 (FCC Conformity assessment)
ISSUE#7
2009-05-26
Applied new layout + minor editing
Edited PCB pad design par.13.1.6
ISSUE#8
2009-06-18
Updated all schematic drawings
Updated Chapter 10 Audio Section
Substituted GE865-QUAD with GE865
Corrected GE864-QUAD/PY with GE865
Updated Overview section
ISSUE#9
2009-07-27
Changed par. 5.1 Turning ON…. and par. 6.1 Power supply Requirements
Changed par. 13.3 and par.15 Conformity Assessment Issues
ISSUE#10
2009-09-22
Added DVI pins description
Updated table of power consumptions.
Added note on chapters 5.1, 5.2, 9.3
Corrected chapter 1.1
ISSUE#11
2010-07-12
Updated logic levels specification
Added NOTE on ON_OFF procedure, serial port , GPIO section
Corrected note on RESET section
Updated Current Consumptions
Updated flow charts for ON OFF and Reset
Updated name for Auxiliary UART port
Updated Chapter 7
Updated Chapter 14
ISSUE#12
2010-07-28
Updated Chapters 13.2, 13.5, 13.6, 14, 14.3.
ISSUE#13
2011-10-11
Updated Chapter 4.1-Reset-internal pull-up
Updated Chapter 14.3 Moisture sensibility – add details
Updated Chapter 16. Safety Recommendations – updated with FCC and IC
requirements
ISSUE#14
2012-03-12
Updated page 44 cut the sentence about the PULL-UP resistor on TX RTS and CTS
ISSUE#15
2012-04-23
Solder paste chapter updated, added Power consumption plots section, added serial
port behavior section, cut Buzzer section
ISSUE#16
2013-04-22
Updated Chapter 15 Conformity Assessment Issues