User's Manual

User Manual-Smart Tag Location
Version:
1.7
Date:
07-04-14
Page:
5 of 12
© buddi Ltd 2012
Talbot House, 17 Church Street, Rickmansworth, Hertfordshire WD3 1DE.
e) Removal Tool- One is required to release the strap and remove the Smart Tag
from the subject. It punctures very small holes in a very controlled location on
the Locking Plates and releases the strap. Not shown above.
3. Smart Tag Fitting
The Smart Tag should be prepared for fitting to the subject by clipping two new
Locking Plates in position as shown below in red for clarity.
The Locking Pates will be secured in position when the Strap is inserted into the
Smart Tag, they protect the strap from being released without physical damage
being created for evidence gathering purposes.
Measure around the ankle, holding the measuring tape loosely. Record the measure
in millimetres (mm).
Using the strap sizing reference material select the strap size recommended for the
subjects ankle measurement.
Fit the Strap into the Smart Tag at one side, then wrap around the ankle of the
subject ensuring the arrow on the front surface is pointing upwards, and connect
the free end of the Strap into the Smart Tag. A clear ‘click’ will be heard as the Strap
securely engages inside the Smart Tag, it should be possible to slip two fingers
behind the strap to ensure enough movement for cleaning, charging and general
comfort.