User's Manual

User Manual-Smart Tag Location
Version:
1.8
Date:
07-04-14
Page:
7 of 12
© buddi Ltd 2012
Talbot House, 17 Church Street, Rickmansworth, Hertfordshire WD3 1DE.
6. On Body Charger
The Smart Tag on-board battery will require recharging at intervals consistent
with the operating mode being used. It is intended that the OBC is connected to
a mains power supply when not in use, to charge up the device in preparation
for connection to the Smart Tag, to fully charge the OBC it should be connected
for 4 hours.
In cases where the OBC has not been charged prior to use it is possible to attach
the unit to the Smart Tag with the OBC connected directly to the mains power
supply, however this is not recommended practice – although a break-away
extender cable is provided for such circumstances. The OBC will fully charge the
Smart Tag in less than 2 hours.
The equipment is attached to the Smart Tag for charging in a secure manner by
locating the OBC over the unit and closing the sliding clip, so as to allow free
movement of the wearer and continuous electrical contact. This only requires a
hand operated force which is deemed ‘reasonable’ and ‘convenient’ to the
wearer. The attachment clip is capable of being attached and removed
repeatedly, the number of cycles will comfortably exceed the lifetime of the
product. The mass of the OBC is 240g.