User's Manual

User Manual
-
Smart Tag
4
Installation Manual
Version:
1.2
Date:
07-04-141
Page: 4 of 11
© buddi Ltd 2021
Talbot House, 17 Church Street, Rickmansworth, Hertfordshire WD3 1DE.
1. Introduction
This document is intended to be the source reference material for using the Smart
Tag V4 product, with the exception of electronic configuration (including set-up and
interaction with the on-line monitoring portal). The emphasis here is upon describing
the physical features, charging, correct fitting and removal etc.
2. Equipment Description
A. On-Body Charger (OBC) Dock – used to charge the On-Body Charger (OBC) battery.
The OBC Dock is plugged into the mains and the OBC is clipped over it during
charging.
B. On-Body Charger (OBC) – used to daily charge the Smart Tag battery. The OBC is
clipped over the Smart Tag during charging.
C. Smart Tag Strap – for securing the Smart Tag to a subject. The strap is available in
a number of sizes depending on the subject’s ankle size.
D. Smart Tag- Ankle worn electronic monitoring device. One is required per subject.
E. Locking Plate- Two plastic Locking plates are required per Smart Tag. The locking
plates will be damaged upon removal of the Strap, therefore new locking plates
must be installed in the Smart Tag before it can be fitted to a new Subject.
F. Removal Tool – is used to release the strap and remove the Smart Tag from the
subject. It punctures very small holes in a very controlled location on the Locking
Plates and releases the strap. Not shown above.