Instructions / Assembly

ManualsBrandsBuddy Products ManualsKitchenSmall Electronic Drawer Safe

step 1

step 6

step 2

3211

cont. on next page

OPENING THE SAFE

All safes are shipped locked. The process of

opening the safe for the first time will be the

same process to follow to perform a manual

override or when the batteries are replaced.

1. To open the safe, remove the small center

cover plate on the front panel.

2. Insert the key into the keyhole. Turn it in a

counter-clockwise direction, and turn the

knob in a clockwise direction and pull.

3. Remove keys. Be sure to store keys in a

secure location, DO NOT STORE KEYS

INSIDE THE SAFE!

INST

ALLING THE BATTERIES

4. Remove the battery cover plate on back of

safe door.

5. Install four AA batteries as marked on

inside of battery chamber.

NOTE: Four

AA batteries are included.

Alkaline batteries are recommended for best

performance.

PROGRAMMING THE CODE

6. View the back of the door and locate the

red button on the left side near the hinge.

Press button and release. You will hear two

beeps and the yellow light on the front of the

safe that reads “proceed” will be lit.

OPERATING INSTRUCTIONS

#3211 Small Electronic Drawer Safe

CAUTION: DO NOT STORE KEYS IN THE SAFE!

7. Press between three and eight numbers

that you wish to use as your new personal

code, and confirm by pressing either “A” or

“B” within 15 seconds. If you do not com-

plete the process correctly, you will have to

start over from step 6.

8. Write down your personal code IMMEDI-

ATELY! Close the safe door and lock unit

by turning the knob counter-clockwise.

USING

YOUR SAFE

9. Check wether your new code has been

programmed correctly. Enter your new code

and then press the letters “A” or “B” to con-

firm. If you have entered it correctly, you will

hear a beep and the green “ready” light will

go on. Note:

You must open the door

using the knob within 5 seconds of

entering the code.

10. If your new code is not opening the

safe, use the keys provided to manually

open the unit as outlined in steps 1-3 and

then proceed to step 6.

NOTE:

If you or an intruder uses the

incorrect code, the safe will not open. If

an incorrect code is used three times in

a row, you must wait approximately 20

seconds before trying again.

If once again the incorrect code is

selected 3 times, you must wait approxi

mately 5 minutes before trying again.

step 9

step 7

OPERATING INSTRUCTIONS

#3211 Small Electronic Drawer Safe

CAUTION: DO NOT STORE KEYS IN THE SAFE!

Summary of content (2 pages)

PAGE 1
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS #3211 Small Electronic Drawer Safe #3211 Small Electronic Drawer Safe CAUTION: DO NOT STORE KEYS IN THE SAFE! CAUTION: DO NOT STORE KEYS IN THE SAFE! OPENING THE SAFE All safes are shipped locked. The process of opening the safe for the first time will be the same process to follow to perform a manual override or when the batteries are replaced. 1. To open the safe, remove the small center cover plate on the front panel. 7.
PAGE 2
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS #3211 Small Electronic Drawer Safe #3211 Small Electronic Drawer Safe BATTERY REPLACEMENT WARNING If the batteries are low, the red “low battery light” will warn you immediately. To test the batteries, just input your personal code to open the door. If the batteries are low, the red light will be on; replace the batteries and reprogram the safe using steps 6-9. NOTE: You must reprogram the code EVERY TIME after replacing batteries.