G115 Direct Vent Installation Instructions

IMPORTANT NOTICES:

ADVISE OWNER to keep intake and exhaust terminations free of debris and snow.

Warning

: Buderus Hydronic Systems, Inc. will not assume any responsibility for the possible

effects of an obstructed air intake or exhaust termination.

NOTE

: MAKE SURE THE BURNER OBSERVATION PORT LOCATED ON THE BURNER

DOOR IS SEALED AIR-TIGHT BY PROPERLY TIGHTENING THE PORT SCREW. USE

EXTRA SILICONE SEALANT IF NECESSARY. TIGHTEN BURNER DOOR BOLTS EVENLY

AND ENSURE AN AIR-TIGHT SEAL.

NOTE

: SURFACE DISCOLORATION ON THE OUTSIDE OF THE BUILDING MAY OCCUR

IF THE BURNER IS NOT PROPERLY ADJUSTED. BUDERUS HYDRONIC SYSTEMS, INC.

WILL NOT ACCEPT ANY RESPONSIBILITY FOR SUCH DISCOLORATION.

NOTE

: Buderus Hydronic Systems, Inc. strongly recommends the use of a low micron oil filter such as

the Garber oil filter, placed in the fuel line near the burner. This filter is in addition to a regular oil filter

placed at the outlet of the oil tank.