Install Instructions

Installing the boiler

Logano G115 WS US/CA – 6 720 813 418 (2014/10) 15

4.2 Reversing boiler door

The burner door is factory-fitted with the hinges on the right – the burner

door opens to the right.You can change the burner door hinges over to

the left-hand side if desired to suit the installation site.

Remove the burner hood/burner door panel first

( Chapter 3.1, page 12).

▶ Removing the burner door ( Chapter 3.1, page 12).

▶ Unscrew the hinge bolts and remove the hinges.

▶ Mount the hinges on the left-hand side of the boiler using the hinge

bolts.

Fig. 8 Reversing the burner door (boiler heat exchanger attachments)

[1] Hinge bolts

[2] Hinges

▶ First remove the hinge lobe bolts and then the hinge lobes. Mount the

hinge barrels on the left-hand side of the boiler using the hinge-barrel

bolts.

▶ Hook the burner door with the hinge lobes onto the hinges.

▶ Check that the heat exchanger baffles are placed horizontally

( Chapter 6.3, page 29).

▶ Close the burner door and secure with the two hexagon-head

bolts.Tighten the hexagon-head bolts evenly (approx. 90 Lbs/inch)

so that the burner door seals properly.

Fig. 9 Reversing the burner door (door attachments)

[1] Hinge-barrel bolts

[2] Hinge lobes

[3] Burner door

[4] Hinges

[5] Heat exchanger baffle plates

7 747 019 141-08.1RS

12 21

If the burner door hinges have been changed over to the

left-hand side, the burner cable must be disconnected

from the burner before opening the burner door.

7 747 019 141-09.1RS