Installation/Maintenance Guide

5
Installation
Logano G201 - Subject to technical modifications.
16
5 Installation
5.1 Fitting the flange of the supply and
return connections
V Remove the flange for the supply connection [1] from
the combustion chamber.
V Loosen the nuts on the flange for the return connection
[2] and remove the flange.
V Place the gaskets [3] on the flange.
V Screw the flange with gaskets onto the supply and
return connection. Check that the gaskets are seated
correctly.
Fig. 9 Fitting the flange of the supply and return con-
nector
1 Supply connection flange
2 Return connection flange
3 Gasket
The flange for the supply connection [1] is in
the combustion chamber. The flange for the
return connection [2] is fastened to the rear
wall with two nuts at the factory.