Installation/Maintenance Guide

Installation

Logano G201 - Subject to technical modifications.

5.2.3 Fitting the side panels

The fitting sequence is the same for the right and left side

panels; proceed as follows:

V Loosen the counternut [2] of the lower anchor rod [4]

(front) until there is a small gap between the counternut

and the nut.

V Hook the front connecting bracket [1] of the side panel

into the resulting gap.

The front connecting bracket of the side panel sits on

the anchor rod [4].

V Hook the rear part of the side panel into the anchor rod.

Fig. 12 Fitting the side panels

1 Front connecting bracket

2 Counternut

3 Nut

4 Anchor rod

V Position and tighten the front and rear tie-bars

(Æ Fig. 13).

V Tighten the counternut of the lower anchor rod (front)

above the open ash pan door.

V Tighten all nuts and bolts.

Fig. 13 Fitting the side panels