Install Instructions
Table Of Contents
- 1 Safety Considerations
- 2 Product Description
- 3 Technical information
- 4 Packaging and Components
- 5 Moving the boiler
- 6 Placing the Boiler
- 7 Boiler block assembly
- 7.1 Assembly when delivered in sections
- 7.2 Check for leaks
- 8.2 Installation of water connections
- 8.2.1 Installing B-Kit:
- 8.2.2 Installation of boiler drain (included in B-Kit)
- 8.2.3 Installation of system components
- 8.3 Filling heating system and checking for water leaks
- 8.4 Burner installation
- 8.5 Providing a fuel supply
- 8.6 Aquastat installation
- 8.7 Electrical connections
- 8.7.3 Electrical connections and connection of additional components
- WARNING!
- 8.7.4 Strain relief installation
- 8.8 Jacket panel installation
- 9 Placing the boiler in operation
- 9.9 Start-up protocol
- 11.3 Boiler cleaning
- 11.6 Inspection and maintenance protocols
- 16 Table of Key Words
Moving the boiler 5
13
We reserve the right to make any changes due to technical modifications.
Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
5 Moving the boiler
This chapter details how to move the boiler safely.
CAUTION!
SYSTEM DAMAGE
due to bumps.
z Please observe the handling directions
on the packaging to protect
components from bumps and rough
treatment.
NOTICE
Protect boiler connections from damage
and dirt if the boiler is not installed
immediately.
NOTICE
Dispose of packaging in an
environmentally responsible manner.
CAUTION!
RISK OF INJURY
by not securing the boiler adequately
during transport.
z Use only suitable means for
transportation, e.g. a trolley with strap,
a stair or step trolley.
z Secure the load against falling.