Install Instructions
Table Of Contents
- 1 Safety Considerations
- 2 Product Description
- 3 Technical information
- 4 Packaging and Components
- 5 Moving the boiler
- 6 Placing the Boiler
- 7 Boiler block assembly
- 7.1 Assembly when delivered in sections
- 7.2 Check for leaks
- 8.2 Installation of water connections
- 8.2.1 Installing B-Kit:
- 8.2.2 Installation of boiler drain (included in B-Kit)
- 8.2.3 Installation of system components
- 8.3 Filling heating system and checking for water leaks
- 8.4 Burner installation
- 8.5 Providing a fuel supply
- 8.6 Aquastat installation
- 8.7 Electrical connections
- 8.7.3 Electrical connections and connection of additional components
- WARNING!
- 8.7.4 Strain relief installation
- 8.8 Jacket panel installation
- 9 Placing the boiler in operation
- 9.9 Start-up protocol
- 11.3 Boiler cleaning
- 11.6 Inspection and maintenance protocols
- 16 Table of Key Words
Boiler maintenance 11
49
We reserve the right to make any changes due to technical modifications.
Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
11.3 Boiler cleaning
The boiler can be cleaned with brushes and/or by a wet
method. Cleaning equipment is available as accessory.
z Open burner door by removing the two hexagon bolts
on the sides.
11.3.1 Cleaning the boiler with cleaning brushes
z Note the position of the flue gas baffle plates to
enable their correct re-installation later.
z Remove the flue gas baffle plates from the flue gas
flues.
z Clean the flue gas baffle plates with one of the two
cleaning brushes.
z Clean the flue passages by turning the round
cleaning brush.
CAUTION!
DANGER OF BURNS
by touching hot boiler parts.
z Wear appropriate protective gloves or
use pliers.
Fig. 68 Open the burner door
1 Combustion chamber
2 1. flue gas pass
3 2. flue gas pass
1
3
2
Fig. 69 Brushing out the flue gas passages