Installation Instructions

Installing the boiler

Logano G115 WS US/CA - Technical specifications are subject to change without prior notice.

4.2 Reversing boiler door

The burner door is factory-fitted with the hinges on the

right – the burner door opens to the right.You can change

the burner door hinges over to the left-hand side if desired

to suit the installation site.

Remove the burner hood/burner door panel first

(Æ Chapter 3.1, page 12).

V Removing the burner door (Æ Chapter 3.1, page 12).

V Unscrew the hinge bolts and remove the hinges.

V Mount the hinges on the left-hand side of the boiler

using the hinge bolts.

Fig. 8 Reversing the burner door (boiler heat

exchanger attachments)

1 Hinge bolts

2 Hinges

V First remove the hinge lobe bolts and then the hinge

lobes. Mount the hinge barrels on the left-hand side of

the boiler using the hinge-barrel bolts.

V Hook the burner door with the hinge lobes onto the

hinges.

V Check that the heat exchanger baffles are placed hori-

zontally (Æ Chapter 6.3, page 29).

V Close the burner door and secure with the two hexa-

gon-head bolts.Tighten the hexagon-head bolts evenly

(approx. 90 Lbs/inch) so that the burner door seals

properly.

Fig. 9 Reversing the burner door (door attachments)

1 Hinge-barrel bolts

2 Hinge lobes

3 Burner door

4 Hinges

5 Heat exchanger baffle plates

7 747 019 141-08.1RS

12 21

If the burner door hinges have been changed

over to the left-hand side, the burner cable

must be disconnected from the burner before

opening the burner door.

7 747 019 141-09.1RS