Operating Instructions
Table Of Contents
- Contents
- 1 Explanation of symbols and safety instructions
- 1.1 Guideline to symbols
- 1.2 Safety instructions
- 2 Product description
- 3 Network interface
- 4 Operating basics
- 5 Incorporation of Logamatic 4000 in LON networks via Logamatic LON-Gateway
- 6 The LON-Gateway as LonMark object
- 7 Error list
Technical Information Logamatic LON-Gateway- Subject to modifications resulting from technical improvements!
21
Network interface
3
3.2.5 Floor-standing boilers
This section describes "floor-standing boiler 1."
For boiler 2, the details apply accordingly.
x = the bit is not used
Boiler with Logamatic EMS boiler output
Example:
Result: 64 + 32 + 4 = 100% (only evaluate second byte)
X - is not used
Note:
230 °F (110 °C) is an invalid value (e.g. no temperature sensor connected, sensor defective, etc.).
47 Status burner boiler 1 SNVT_state(83) nvoKS1Br1Stufe1 2
Tab. 34 Display of the current burner level in operation and/or display of the current boiler
output for boilers with Logamatic EMS
Boiler with Logamatic 4000
Burner 1st level on Burner 2nd level on / modulating
High byte Low byte High byte Low byte
OFF xxxx xxxx 0xxx xxxx xxxx xxxx x0xx xxxx
ON xxxx xxxx 1xxx xxxx xxxx xxxx x1xx xxxx
Tab. 35
First byte Second byte
Factor 12481632641281248163264128
Display x x x x x x x x 0 0 1 0 0 1 1 0
Tab. 36
49 Boiler supply temperature (FK) actual SNVT_temp_p(105) nvoKS1VLIst_Tp 2
Tab. 37 Display of the currently-measured supply temperature for a floor-standing multi-boiler
system