Operating instructions

Extended functions 8
37
We reserve the right to make any changes due to technical modifications.
Operating instructions RC30 programmable room thermostat • Issue 02/2006
8.7 Changing settings for another heating circuit
Room temperature and operating mode
Your heating system may be equipped with several heating circuits
(see Section 2.5, page 9). If you want to change the room
temperature or operating mode for a different heating circuit than
the one last selected, first select the required heating circuit.
Subject to the equipment level of your heating system, the
following heating circuits can be selected:
– RC30 heating circuits ("RC30 HEATCIR", all heating circuits
that are assigned to the RC30, see "RC30 heating circuits"
page 36)
– Heating circuit 1 or 2 (not available if more than one heating
circuit is assigned to the RC30)
If more than one heating circuit is assigned to the RC30, the room
temperature and operating mode for these heating circuits can
only be set together. Otherwise the message "RC30 HEATCRC
SELECT" is displayed. In such a case select "RC30 HEATCIR".
Hold down the "Heating circuit" button and select the required
heating circuit with the dial (here: "HEAT CIRC 2").
Release the "Heating circuit" button. The displayed heating circuit
is now selected.
As soon as heating circuit has been selected, the display returns
to the standard display.
+
HEAT CIRC
HEAT CIRC 2
ACTUAL
ROOM TEMP
21.5
°