Operating instructions

Logamatic EMS RC35 programming unit - Subject to technical modifications
13
Principles of operation
4
4.3 Setting the operating mode
You can activate the operating mode directly by pressing the button shown.
Operating mode Button Meaning
automatic operation
(recommended setting)
The switching program is active. The system will switch
over automatically between day mode and night mode
at a set time (switching point).
1)
At night the heating
system will operate with a reduced room temperature
(factory setting; night shutdown is also possible).
DHW heating is on during the day and off at night
(factory setting).
The LED for the automatic button is lit up, along with the
LED for either day or night mode, depending on which
is currently active.
1) The automatic day and night modes correspond to the manual day and night modes. The only difference lies
in the automatic switchover.
continuous heating
(manual day mode)
Factory setting: 21 °C. Manual day mode is useful if you
want to heat outside the usual times. Automatic mode is
switched off.
DHW heating is on (factory setting).
Only the day mode LED is lit up.
permanently reduced
(manual night mode)
Factory setting: 17 °C. The heating system operates
with a reduced room temperature (factory setting).
Manual night mode is useful if you are occasionally
absent for long periods. Automatic mode is switched
off.
DHW heating is off (factory setting).
Only the night mode LED is lit up.
Tab. 4 Meaning of the operating modes
The settings made using the buttons above apply to all heating circuits assigned to the
RC35 programming unit (these are referred to as the “RC35 heat. circuits”,
Æ page 26).
To set the operating mode for other heating circuits: use the user menu\operation
modes (Æ Page 29).