Operating instructions

Principles of operation
Logamatic EMS RC35 programming unit - Subject to technical modifications
14
4
4.4 Changing the room temperature temporarily
Follow this procedure if you only want to change the room temperature up until the next switching
point. At the switching point, the system switches over automatically between day and night modes
(Æ page 31). The heating system will then go back to the standard room temperature setting.
Initial situation: the flap is closed.
Ending a temporary change in room temperature
B To return to automatic mode: press .
The automatic program uses the temperatures normally set for day and night mode.
-or-
B To return to manual mode: press or .
The temperatures normally set for day or night mode will be used.
Operation Result
1. Turn rotary selector .
The current room temperature setting starts flashing.
Turn rotary selector further. Turn the rotary selector
clockwise to increase the room temperature and anti-
clockwise to lower it.
2. When you have reached the required room temperature:
release the rotary selector.
The modified room temperature is saved (and stops flashing).
The standard display reappears.
In manual mode, the LED next to is not lit up. In this case, the modified room
temperature applies until you press , or .
Tab. 5
If the heating system is equipped with a RC2x remote control (Æ page 27), and the date
of manufacture of the remote control is January 2006 or later, the room temperature can
also be modified temporarily at the remote control.
SET ROOM TEMPERATURE
Until next switch
point, room temp.
changed to:
SET ROOM TEMPERATURE
Until next switch
point, room temp.
changed to: