Operating instructions

Operation with the user menu

Logamatic EMS RC35 programming unit - Subject to technical modifications

Designations of the heating circuits in the example in Fig. 2

When you make adjustments to a particular heating circuit, first select the appropriate heating

circuit. A list of designations as shown in Tab. 11 is available for selection.

Different temperatures for the heating circuits (Æ Tab. 11, [1] b) can also be entered using the

RC35 programming unit without a remote control, if your heating contractor has made

corresponding settings. In this case, the room temperatures for the separate heating circuit can be

set via the user menu (Æ page 37).

Fig. 2 For heating circuit 1+2:

Designation of the heating

circuits on the display

Setting the room

temperature

[1] Identical room temperature

(factory setting)

HC1+HC2 = RC35 heat. circuits

1) No heating circuit selection is possible if no other heating circuit is available, e.g. DHW.

Page 14 – 16

[1] Different room temperatures

possible

2) Here: adjustment by the heating contractor HC 1 = none, HC 2 = RC35.

HC1 = heating circuit 1

HC2 = RC35 heat. circuits

HC1: page 16 or 37

HC2: page 14 – 16

[2] Different room temperatures

possible

HC1 = heating circuit 1

HC2 = RC35 heat. circuits

HC1: via RC2x

HC2: page 14 – 16

Tab. 11 Designations of the heating circuits in the example in Fig. 2, page 27