Operating instructions

Logamatic EMS RC35 programming unit - Subject to technical modifications

Operation with the user menu

5.4 Selecting the standard display

This menu item can be used to select the default value to be displayed in the upper row of the display

screen (permanent display).

1. Open the user menu.

2. Select standard display. You can choose from the following standard displays:

– date + time (factory setting)

– outside temperature (recorded outside temperature)

– boiler temperature (recorded boiler water temperature, flow temperature)

– DHW temperature (in DHW water cylinder)

– collector temperature (with solar thermal systems only)

5.5 Selecting the operating mode

5.5.1 Operating modes for RC35 heating circuits

The operating mode for the RC35 heat. circuits can be set directly by pressing the corresponding

button (e.g. ). For other heating circuits, use this menu item. If the heating circuit is equipped

with a remote control unit (e.g. RC2x/RC20/RF), you can also use the operating mode keys on the

remote control.

1. Open the user menu.

2. Select operation modes.

3. If your heating system is equipped with more than one heating circuit (Æ page 26): select the

required heating circuit and confirm.

4. Set the operating mode for the selected heating circuit:

– automatic operation (switching program)

– continuous heating (manual day mode)

– permanently reduced (manual night mode)

For more information on the operating modes, refer to page 13.

If there is only one heating circuit installed and no DHW, heating circuit selection is not

possible.