Operating instructions

Logamatic EMS RC35 programming unit - Subject to technical modifications

Operation with the user menu

5.6 Setting the switching program

Automatic mode ensures automatic changeover between day and night mode at defined times. The

factory settings means 21 °C or 17 °C are set for day or night mode.

Before you select a switching program (i.e. a heating program), consider the following:

• At what time in the morning should your home be warm? Is this time also subject to the day of

the week?

• Are there days when you don't want to heat during the day?

• From what time in the evening do you no longer need to heat? This may also depend on the day

of the week.

1. Open the user menu.

2. Select switching programme.

3. If your heating system is equipped with more than one heating circuit (Æ page 26): select the

required heating circuit and confirm. A separate switching program can be set for each heating

circuit.

You will then see the following options:

– select programme (Æ page 32)

– display curr. prog. (Æ page 34)

– change switch point (Æ page 34)

– enter switch point (Æ page 35)

– delete switch point (Æ page 36)

– room temperatures (Æ page 37, not possible for DHW, DHW circulation and solar heating

circuits)

4. Recommended: use the select programme option to select the program which best

corresponds to your lifestyle.

5. If the standard program needs to be adjusted: change, insert or delete individual switching

points.

6. If you want to create a completely new switching program: go to select programme and set a

new programme.

The enter switch point menu item (Æ page 35) opens automatically for you to create your

program.

With the factory settings, the switching program also determines the times for DHW

heating and operation of the DHW circulation pump. However, you can also set

separate switching programs for both functions (Æ Chapter 5.7 and 5.8).