Operating instructions

Logamatic EMS RC35 programming unit - Subject to technical modifications

Operation with the user menu

4. Repeat steps 1 to 3 to change other switching points.

5. Press when you have finished making entries.

6. Hold down and turn the rotary selector, to save the modified program as user defined1 or

user defined2.

The selected program, user defined1 or user defined2, is used from now on for that heating

circuit.

7. Select do not save to cancel.

5.6.4 Entering a switching point

You can use enter switch point to add additional switching points for a heating phase or energy

saving phase (day/night mode) or create a new switching program. You can enter switching points

separately for each day. The minimum time between switching points is 10 min (period for which the

circuit is switched on or off).

1. Turn rotary selector to select the day of the week.

2. Hold down and turn the rotary selector to change the time for that switching point.

The switching point will flash on the graph until it has been entered completely.

3. Hold down and turn the rotary selector to specify whether the point is a start or a stop point.

Once the switching point has been entered completely, all the values flash for three seconds. The

switching point can still be changed during this time. After that the switching point is saved.

4. Repeat steps 1 to 3 to enter other switching points.

5. Turn rotary selector to go to other days.

6. Press when you have finished making entries.

If you have changed the program and then do not press any button for five minutes, the

system assumes you have finished making entries and goes on to the next step.

If you want to set switching points for a block of days (Mo-Th, Mo-Fr, Mo-Su, Sa-Su),

select select programme\new programme.

For each start point ([1], day mode), you also need to enter a stop

point ([2], night mode) so that the heating will switch back to night

mode again.

The maximum number of switching points is 42 per heating circuit.