Operating instructions

Operation with the user menu
Logamatic EMS RC35 programming unit - Subject to technical modifications
40
5
5.11 Setting the DHW temperature
The DHW temperature is the temperature to which the water in the DHW cylinder is heated.
1)
1. Open the user menu.
2. Select DHW temperature.
3. Set the required DHW temperature (factory setting: 60 °C).
5.12 Setting holiday mode
Use holiday mode
1)
to run the heating system differently from the standard switching program when
on holiday.
You can only set one holiday period at a time.
1. Open the user menu.
2. Select holiday.
3. Select the heating circuit to be switched over to holiday mode:
– complete system: heating circuits, DHW and DHW circulation
– RC35 heat. circuits: this option is only displayed if one or several heating circuits are
assigned to the RC35; DHW and the other heating circuits remain active.
Should the official details for the changeover change, adjust the summer/wintertime
changeover to no.
B Change the time manually.
1) This function depends on the boiler used.
WARNING: Risk of scalding!
The factory setting for the DHW temperature is 60 °C. There is a risk of scalding at the
draw-off points if the temperature is set higher than this.
B If the temperature set is higher than 60 °C, do not open any hot water tap without
mixing in cold water as well.
You can also enter the same setting without going through the user menu:
B Hold down and simultaneously turn rotary selector .
Should a message be issued that this setting is not possible:
B At the boiler programming unit, turn rotary selector to “AUT” or enable DHW
heating.