Quick Start Guide

Press and hold the POWER button, located on the right side of the HUB,
for two seconds.
POWERING THE HUB ON / OFF
The FREQUENCY ranges from 1 - 16. To set the frequency turn the
ROTARY WHEEL until FREQUENCY appears on the display.
Press in on the ROTARY WHEEL to enter the FREQUENCY section.
Turn the ROTARY WHEEL until your desired frequency appears.
Press in on the ROTARY WHEEL to confirm your selection.
SETTING THE FREQUENCY
Press in on the rotary wheel, located on the left side of the HUB.
This will send a test fire to any flash units that are on the same frequency.
SENDING A TEST FIRE
CHARGING PORT
SYNC JACK
ROTARY WHEEL
TOP HOT SHOE
1
POWER BUTTON
REAR DISPLAY
LOCKING BOTTOM HOT SHOE
(CAMERA BRAND SPECIFIC)
2
3
4
5
6
7
1
2
3
4
5
6
7
By default, BLUETOOTH is ON when the HUB is first activated.
To turn BLUETOOTH ON or OFF, turn the ROTARY WHEEL until
BLUETOOTH appears on the display. Press in on the ROTARY WHEEL
to enter the BLUETOOTH section. Turn the ROTARY WHEEL to toggle
between ON and OFF. Press in on the ROTARY WHEEL to confirm your
selection.
BLUETOOTH
To adjust the display brightness turn the ROTARY WHEEL
until BRIGHTNESS appears on the display.
Press in on the ROTARY WHEEL to enter the BRIGHTNESS section.
Turn the ROTARY WHEEL until your desired brightness appears.
ADJUSTING THE DISPLAY BRIGHTNESS
To set the HUB into TTL mode, turn the ROTARY WHEEL until TTL appears
on the display. Press in on the ROTARY WHEEL to enter the TTL section.
Turn the ROTARY WHEEL to toggle between TTL and MAN (for manual).
Press in on the ROTARY WHEEL to confirm your selection.
TTL MODE
The HUB will enter HSS mode automatically when your camera is set above
it’s max sync speed.The HUB will also superseed any settings found on
the LINK. For example, if the LINK is set to COLOR MODE but you are now
shooting above your camera’s max sync speed, the HUB will then adjust
the LINK and place it into HSS MODE.
HSS MODE
FREQUENCY
TTL/MAN and HSS
BATTERY INDICATOR
BLUETOOTH
8
9
10
11
8
10
11
9
12”
4”
INDICATORS - DO NOT PRINT
CROP MARKS
FINAL SIZE
FOLD
INTERIOR
ABOUT
To access the serial number, current firmware version, and FCC ID within
the HUB interface, first turn on the HUB and use the rotary dial to scroll
to the ‘ABOUT’ section. Then, once ‘ABOUT’ appears on the display,
press in on the rotary dial to enter the section. Finally, scroll using the
rotary dial to view each item.