HD-HSIU2 DriveStation HD-HSIU2 Series QUICK SETUP GUIDE www.buffalo-technology.
EN DriveStation HD-HSIU2 Series Package Contents Thank you for purchasing a Buffalo DriveStation. Package contents include: • DriveStation • USB 2.0 Cable • FireWire (IEEE1394) Cable • Quick Setup Guide • Setup CD-ROM • Warranty Statement Introduction The Buffalo TurboUSB utility can greatly improve the data transfer rates to and from your Buffalo USB hard drive. The utility cannot be used with other USB devices. 1 Installation Insert your DriveNavigator CD in your computer’s CD drive.
EN 2 Using TurboUSB To use TurboUSB, you must first enable it. From the Start menu, choose Programs > BUFFALO > TurboUSB > TurboUSB for HD-HSIU2. (Fig: 2) Fig: 2 Click Enable and follow the instructions. (Fig: 3) Fig: 3 Once the wizard has completed you must disconnect the DriveStation by clicking on the ‘Safely Remove Hardware’ icon in the systray (located in the taskbar) (Fig: 5). Once indicated, remove and reattach the USB cable from your PC to finalise activation of TurboUSB.
EN 2 Using TurboUSB Fig: 4 Fig: 5 You may also turn TurboUSB off from the same window by clicking Disable and following the steps (Fig: 3). You must then unplug and reconnect the USB hard drive to finalise the process. Use the ‘Safely Remove Hardware’ wizard to release the drive before unplugging it.
EN 3 Is TurboUSB enabled? To check whether TurboUSB is enabled, right-click on My Computer and choose Properties > Hardware > Device Manager > Universal Serial Bus controllers. If TurboUSB is enabled, your USB storage device will have “(TurboUSB)” added to its name. (Fig: 6) Fig: 6 4 Uninstalling To remove the Buffalo TurboUSB utility from your computer, click Start > Programs > BUFFALO > TurboUSB > Uninstaller. This will launch an uninstall screen. Click on Start to run the uninstallation.
EN TurboUSB For Mac The Buffalo TurboUSB utility can greatly improve the data transfer rates to and from your Buffalo USB hard drive. Other USB devices are not affected by TurboUSB software. 1 Installation and Using TurboUSB 1. Insert the Buffalo Technology CD in your computer CD drive 2. Double-click on TurboUSB.dmg. 3. Navigate to the “TurboUSB” directory on the Desktop and double-click on TurboUSBHDDInstall. 4. After the Buffalo TurboUSB software is installed, click Restart.* * You must restart your Mac.
EN FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CE Mark Warning This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
