User's Manual
Table Of Contents
- User Manual
- Chapter 1 - Product Overview
- Chapter 2 - Installation
- Chapter 3 - Connect to a Wireless Network
- Chapter 4 - Client Manager
- Software Overview
- Using Client Manager V
- Opening and Closing Client Manager
- Main Screen
- Automatic Secure Setup and Advanced Setup
- SSID / WPS-PIN selection
- Searching Wireless Access Points
- Wireless Network Information
- WPS-PBC / AOSS selection
- Wireless Status
- Wireless LAN Diagnostic
- Profile List
- Wireless Properties
- Network Properties
- Browser Properties
- Printer Properties
- Using Client Manager 3
- Chapter 5 - Trouble Shooting
- Appendix
WI-U2-800D / WI-U2-400D User Manual 72
Appendix
Compliance Information
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of
other channels is not possible.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor
environment only.
Federal Communication Commission (FCC) Radiation Exposure Statement:
This EUT is compliance with SAR for general population/uncontrolled exposure limits
in ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods and
procedures specified in OET Bulletin 65 Supplement C.T his equipment should be installed and
operated with minimum distance 0.5 cm between the radiator & your body.