User's Manual
Table Of Contents
- User Manual
- Chapter 1 - Setup
- Chapter 2 - Settings
- Easy Admin
- Advanced Settings
- Internet
- PPPoE
- Dynamic DNS
- PPTP
- NAT
- LAN
- DHCP Lease
- Routing
- 2.4 GHz
- 5 GHz
- WPS
- AOSS
- MAC Filtering
- Multicast Control
- Guest Account
- Wireless Bridge
- Firewall
- IP Filter
- VPN Passthrough
- Port Forwarding
- DMZ
- UPnP
- Web Filtering and Parental Controls
- Disk Management
- Sharing
- WebAccess
- Media Server
- BitTorrent
- QoS
- eco Mode
- Network USB
- System
- Syslog Settings
- Reset / Reboot
- Update
- System Information
- Logs
- Packets
- Ping
- Chapter 3 - Wireless
- Chapter 4 - Utilities
- Chapter 5 - Troubleshooting
- Appendix A - Supplemental Information
- Appendix B - Tutorials
- Configuring the AirStation for Optimal Performance and Security
- Sharing a Printer
- Configuring Parental Controls
- Port Forwarding Basics
- Setting Up Port Forwarding Rules
- Configuring a USB Drive as a NAS
- Adding a Second AirStation as a Wireless Client
- Saving and Restoring Settings
- Setting Up WebAccess
- Connecting Wireless Devices Using AOSS
- Setting Up a VPN Server
- Using AirStations with 2Wire Residential Gateways
- How to Use QoS
- How to configure TCP/IP
27
PPPoE Connection
This is displayed when [Edit Connection List] is clicked.
Name of Connection
Enter the name to identify the connected destination. You may enter up to 32
alphanumerical characters and symbols.
Username
Enter the username specified by your ISP for PPPoE certification. You may enter up to 64
alphanumerical characters and symbols.
Password
Enter the password specified by your ISP for PPPoE certification. You may enter up to 64
alphanumerical characters and symbols.
Service Name
Fill in this field only if your ISP specifies a service name. Leave blank otherwise. You may
enter up to 64 alphanumerical characters and symbols.
Connection Type
Specifies the timing for the AirStation to connect to your provider.
Automatic Disconnection
Set time to disconnect after communication is stopped when the connection method is
set to [Connection on Demand] or [Manual]. You can enter up to 1440 minutes.
Authentication
Configure an authentication method with a provider.
MTU Size
Configure the MTU size for PPPoE. Values of 578 to 1492 bytes may be entered.
MRU Size
Configure MRU (maximum receive unit) for PPPoE. Values of 578 to 1492 may be
entered.
Keepalive
If keepalive is enabled, the AirStation will issue an LCP echo request once a minute in
order to maintain the connection with the PPPoE. If the server does not respond for
more than 6 minutes, the line is recognized as disconnected and the AirStation will
terminate the connection. Disabled by default.
Preferred Connections Displays information you have set regarding to the connection destination route.
Edit Preferred
Connections
Click to edit the connection destination route settings.
Preferred PPPoE
Connection
Click [Edit Preferred Connections] to display.
Name
The destination to connect by PPPoE if [Destination Address] and [Source Address]
match. Select the destination registered to the PPPoE Connection List.
Destination Address
When communicating to this address, the AirStation will communicate with [Name].
Source Address
When communicating from this address, the AirStation will communicate with [Name].