User Manual
Table Of Contents
- Chapter 1 - Product Overview
- Chapter 2 - Installation
- Chapter 3 - Connect to a Wireless Network
- Chapter 4 - Client Manager
- Software Overview
- Using Client Manager V
- Opening and Closing Client Manager
- Main Screen
- Automatic Secure Setup and Advanced Setup
- SSID / WPS-PIN selection
- Searching Wireless Access Points
- Wireless Network Information
- WPS-PBC / AOSS selection
- Wireless Status
- Wireless LAN Diagnostic
- Profile List
- Wireless Properties
- Network Properties
- Browser Properties
- Printer Properties
- Using Client Manager 3
- Chapter 5 - Trouble Shooting
- Appendix
WLI-UC-G450 User Manual 64
Appendix
450 Mbps Mode Settings
By default, the AirStation’s 450 Mbps mode is disabled. Use the following proceedure to enable it if
desired.
1. Click [Start] > [All Programs] > [BUFFALO] > [AirStation Utility] > [AirStation Bandwidth 20 or
40 MHz Select Tool] and launch the utility software.
If the User Account Control screen is displayed, click [Yes] or [Continue].
2. When the message “Now start the setup wizard of Bandwidth Select Tool” is displayed, click
[Next].
3. Click [Next].
4. When the message "Select wireless adapter" appears, select this unit and click [Next].
5. Select "Use 450 Mbps Mode (40 MHz)", and click [Next].
6. When the message "Wireless adapter setting is completed" is displayed, click [Exit to setup].
If you still cannot establish a 450 Mbps connection, check the settings for your access point.