Operation Manual

Static Default Gateway
Enter the default gateway to configure an IPv6 default gateway manually. The
default gateway prefix should be the same as the static global address.
Dynamic Global Address
Displays the dynamic global address obtained from DHCPv6 or router
advertisement.
The address with the trailing “SF” means that the address was obtained from
DHCPv6. The address with the trailing “SL” means that the address was obtained
from router advertisement.
Dynamic Default Gateway Displays the default gateway obtained from router advertisement.
Note: In L3 mode, you can configure the default gateway from the [Routing] - [Static Routing] page.
VLAN Ports
Configure PVID (Port VLAN ID).
PVID
Specify the port VLAN ID. The received untagged frames will be recognized as the
specified VLAN ID. (1-4094)
Acceptable Frame Type
Admit All
Receive both untagged and tagged frames.
Tag Only
Receive tagged frames only and drop untagged frames.
Ingress Filter
Enable
Drop frames if the received frame’s VLAN ID is not a member of incoming port’s
VLAN.
Disable
All tagged and untagged frames will be received.
Protected Port “Protected Port” enabled ports cannot communicate with each other.
20
Chapter 2 Settings