Operation Manual

DiffServ Policy
Select the action for when the frames satisfy the condition.
Permit
Permits forwarding the frames and packets.
Deny
Discards the frames and packets.
Egress Queue
Changes the processing priority of the frames and packets.
Remark CoS
Rewrites CoS value of the frames and packets.
Remark DSCP
Rewrites DSCP value of the frames and packets.
Remark IP Precedence
Rewrites IP precedence value of the frames and packets.
Profile Action
Processes the frames and packets depending on the committed rate. If the rate
of the frames and packets is less than the committed rate, the switch will process
the frames and packets in accordance with the in-profile action. Otherwise, the
switch will process the frames and packets in accordance with the out-of-profile
action.
Committed Rate
Specify the rate to determine the process method.
Committed Burst
Specify the burst size that the switch processes in accordance with the in-
profile action when the rate of frames and packets exceeds the committed rate
instantaneously. When the burst size exceeds the committed burst, the switch
will process in accordance with the out-of-profile action.
In-Profile Action
Specify the action when the rate of frames and packets is less than the committed
rate.
Out-of-profile Action
Specify the action when the rate of frames and packets exceeds the committed
rate.
About Address and Mask
This product adopts “wildcard masks”. To configure the source IPv6 address or destination IPv6 address, refer to the
following example.
• To specify the range of “2001:db8::” to “2001:db8::ffff”
Enter “2001:db8::” in the address field and also enter “::ffff” in the mask field.
• To specify only “2001:db8::”
Enter “2001:db8::” in the address field and also enter “::” in the mask field.
45
Chapter 2 Settings