User Manual
Table Of Contents
- Chapter 1 Initial Settings
- Chapter 2 Settings
- Menu
- System Information
- System
- VLAN
- Routing
- SNMP Settings
- LLDP
- MAC Addresses
- Port Settings
- System Security
- PoE
- QoS
- Security
- Authentication
- Port Trunking
- Traffic Control
- Mirroring
- Spanning Tree Protocol
- IGMP
- MLD
- ACL
- Loop Prevention
- DHCP Relay
- Update Firmware
- Dual Image
- Back Up and Restore Settings
- Reboot
- Initialize
- ARP Table
- MAC Address Table
- Statistics
- Logs
- Syslog Settings
- Network Diagnostics
- Cable Diagnostics
- Chapter 3 Troubleshooting
- Appendix A Specification
63
MLD
Status
Displays the MLD status.
MLD Status Displays the multicast address table.
Router Port Status Displays the port connected to the multicast router (server).
MLD Settings
Configure MLD snooping.
MLD Snooping
Check to enable MLD snooping.
If enabled, you can prevent the flooding of multicast packets except for the port
connected to the host which joins the multicast group.
Note: FF02::-FF02::FF and FF0X:: will be excepted from MLD snooping.
Filter Unknown Multicasts
If checked, the packets of the multicast that is not learned will be discarded except
for FF02::-FF02::FF and FF0X::.
Host Timeout Enter the host timeout period for receiving multicast.
Router Port Timeout Enter the timeout length for the multicast router (server).