User Manual
Table Of Contents
- Chapter 1 Initial Settings
- Chapter 2 Settings
- Menu
- System Information
- System
- VLAN
- Routing
- SNMP Settings
- LLDP
- MAC Addresses
- Port Settings
- System Security
- PoE
- QoS
- Security
- Authentication
- Port Trunking
- Traffic Control
- Mirroring
- Spanning Tree Protocol
- IGMP
- MLD
- ACL
- Loop Prevention
- DHCP Relay
- Update Firmware
- Dual Image
- Back Up and Restore Settings
- Reboot
- Initialize
- ARP Table
- MAC Address Table
- Statistics
- Logs
- Syslog Settings
- Network Diagnostics
- Cable Diagnostics
- Chapter 3 Troubleshooting
- Appendix A Specification
84
PoE Port Specification (Only for PoE-compatible devices) (Alternative A)
Pin Number Power
1 Negative Vpse
2 Negative Vpse
3 Positive Vpse
4 -
5 -
6 Positive Vpse
7 -
8 -
Factory Default Settings
System
Switch Name BS + the switch's MAC address
Location Not defined
Contact Not defined
VLAN
VLAN Settings
VLAN Mode VLAN
VLAN ID 1
VLAN Name None
Management VLAN Enabled
Connection Method Static IP Address
IPv4 Address 192.168.1.254
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
Method of Acquiring DNS
Server Address
Manual
Primary DNS Server 0.0.0.0
Secondary DNS Server 0.0.0.0
IPv6 Disabled
Ports Untagged
VLAN Ports
PVID 1
Acceptable Frame Type Admit All
Ingress Filter Enabled
Protected Port Disabled
Routing
L2/L3 Settings Mode L2 mode
Static Routing
(L3 mode only)
Default Gateway 0.0.0.0
SNMP Settings
SNMP Community
Table
Community Name "public" for only #1
Get Enabled for only #1
Set Disabled
Trap Disabled
SNMP Host Table Host Authentication Disabled