Manual

126
Amber
If there is a status message, the power LED will blink amber. The pattern of the blink gives the information code. You
can also see any status messages in NAS Navigator2.
Place Status
10s Place
The LED flashes for 1.0 seconds every 0.3 seconds. This gives the tens place
of the information code.
1s Place
The LED flashes for 0.5 seconds every 0.3 seconds. This gives the ones place
of the information code.
Information Code Description Corrective Action
I10 System temperature is too high.
Move the LinkStation to a cool location.
Do not place objects in the area around
the LinkStation.
I11 Drive x has too many bad sectors. Replace hard drive x.
I12 Operating in degraded mode. -
I13 Formatting RAID array x. -
I14 Checking RAID array x. -
I15
Examining the error status of RAID array
x.
Note: Transfer speeds are slower during
the examination process.
-
I16 Creating RAID array x. -
I17
Resynchronizing RAID array x.
Note: Transfer speeds are slower during
resynchronization.
-
I18
Rebuilding RAID array x.
Note: Transfer speeds are slower during
the rebuilding process.
-
I19
Writing 0s to RAID array x, erasing all
data.
-
I20 Formatting hard drive x. -
I21 Checking hard drive x. -
I22 Erasing the data for hard drive x. -
I23 System is being initialized. -
I25 Updating the LinkStation firmware. -
I26 Initializing all settings. Don't turn off the LinkStation.
I27 Checking USB hard drive. -
I28 Formatting USB hard drive. Don't turn off the LinkStation.
I46
Data migration or conversion (RAID
migration) is in progress.
Don't turn off the LinkStation.
I47
Data migration or conversion (RAID
migration) is in progress.
Don't turn off the LinkStation.
I52
A new firmware version has been
released.
Update the firmware.