User Manual

3 An icon for the mapped share will appear in Computer or This PC. You can use this network drive just like any
other drive.
Changing the IP Address
1 Double-click the NAS Navigator2 icon ( ) to start NAS Navigator2.
2 Right-click your Buffalo NAS device’s icon and select Properties > IP Address.
3 Clear the “Use DHCP” checkbox and enter the desired settings, then click OK. If the username and password
prompt appears, enter the admin username and password.
NAS Navigator2 for macOS
NAS Navigator2 is a utility program that makes it easy to display Settings, change the Buffalo NAS device’s IP
address, or check its drive. To install NAS Navigator2, download the installer from http://d.buffalo.jp/LS200/.
Click the NAS Navigator2 icon ( ) in the Dock to start NAS Navigator2.
Click a Buffalo NAS device’s icon to display total capacity, used capacity, workgroup name, IP address, subnet mask,
default gateway, MAC address, and firmware version.
Double-click the icon to open a shared folder on the Buffalo NAS device.
Name Description
Open Opens the Buffalo NAS device’s shared folders.
Refresh Searches for the Buffalo NAS devices on the network again.
Settings Opens Settings for the Buffalo NAS device.
Configure
Opens the properties page that lets you configure the
Buffalo NAS device’s IP address or open Settings.
Label Color Selects the color of the name displayed below the icon.
117
Chapter 9 Utilities