User Manual

Chapter 10 Appendix
When the Power LED Blinks
White
The power LED will blink white during bootup or shutdown.
Red
If there is an error, the power LED will blink red. The pattern of the blink gives the error code. You can also see any
errors in NAS Navigator2.
Place of Error Code Status
10s Place of Error Code
The LED flashes for 1.0 second every 0.3 seconds. This gives the tens place of
the error code.
1s Place of Error Code
The LED flashes for 0.5 seconds every 0.3 seconds. This gives the ones place
of the error code.
Error Code Description Corrective Action
E07 The firmware is corrupted.
Contact Buffalo technical support for
assistance.
E11 An error occurred in the fan speed.
Check that no foreign objects or dust are
clogging the fan. If any foreign objects
or dust are found, use a pair of tweezers,
air duster, or other tools to remove them.
If the error is displayed again, contact
Buffalo technical support for assistance.
E12
A rise in the system temperature may have
exceeded the allowable safety value.
Do not place objects in the area around
the LinkStation. Also, move the LinkStation
to a cool location.
E14 The RAID array cannot be mounted. Run the RAID array drive check in Settings.
E15
The bad sectors have reached a dangerous
level.
Replace the defective drive.
E16 Unable to find the drive.
The drive may be disconnected or may
have failed. Shut down the LinkStation and
reinstall the drive.
E22 Unable to mount the drive.
Format the drive. After formatting, if the
error still appears after rebooting, replace
the drive. If the error is displayed again,
contact Buffalo technical support for
assistance.
E23
An error occurred, so the drive was
removed from the RAID array.
Replace the drive by referring to the “Drive
Replacement” section in chapter 4.
E30
An error occurred, so the drive was
removed from the RAID array.
Replace the drive by referring to the “Drive
Replacement” section in chapter 4.
120
Chapter 10 Appendix