User's Manual
Table Of Contents
- User Manual
- Chapter 1 Getting Started
- Chapter 2 Configuration
- Chapter 3 File Sharing
- Chapter 4 Storage Management
- Chapter 5 Remote Access
- Chapter 6 Backup
- Chapter 7 Multimedia
- Chapter 8 Advanced Features
- Chapter 9 Configuring from Mobile Devices
- Chapter 10 Utilities
- Chapter 11 Appendix
- Chapter 12 Regulatory Compliance Information
125
Chapter 9 Configuring from Mobile Devices
Note: By default, the Direct Copy folder is configured to the "share" folder. You can change the destination
folder from Settings using the computer. Refer to the “Copying from a USB Device” section in chapter 6 for the
procedure.
5 When the copy operation is finished, the access LED of the USB device will stop flashing. Safely dismount the
USB device by using the dismount process.
Enabling a Print Server
1 From Settings, tap [USB Device].
2 Move the print server switch to the on position to enable print server and tap [Apply].
Rebuilding the RAID Array
You can also initiate the RAID rebuild from your mobile device.
1 Turn the LinkStation off and remove all cables.
2 Squeeze the left side of the front panel and swing it open.
3 Push the failed drive’s cartridge up and remove it from the LinkStation.
4 Unscrew the four screws and remove the drive from the cartridge.
5 Install a new drive (sold separately) into the cartridge.