User's Manual

129
Chapter 11 Appendix
Amber (Blinking)
After you change any settings, the power LED will blink amber. The pattern of the blink gives the information code.
You can also confirm the current status by using NAS Navigator2.
Place Status
10s Place
The LED flashes for 1 second every 0.3 seconds. This gives the tens place of
the information code.
1s Place
The LED flashes for 0.5 seconds every 0.3 seconds. This gives the ones place
of the information code.
Code Description Corrective Action
I10
A rise in the system temperature may have
exceeded the allowable safety value.
Move the LinkStation to a cool location. Do
not place objects in the area around the
LinkStation.
I11
The drive has too many bad sectors.
Replace the drive by referring to the “Drive
Replacement” section in chapter 4.
I12
Operating in degraded mode.
Check if the E30 error is also displayed. If
it is, refer to the corrective action for the
E30 error.
I13
Formatting the RAID array. -
I14
Checking the RAID array. -
I15
Examining the error status of the RAID
array.
Note: Transfer speeds are slower during
the examination process.
-
I16
Creating the RAID array. -
I17
Resynchronizing the RAID array.
Note: Transfer speeds are slower during
resynchronization.
-
I18
Rebuilding the RAID array.
Note: Transfer speeds are slower during
the rebuilding process.
-
I19
Rewriting the RAID array. -
I20
Formatting the drive. -
I21
Checking the drive. -
I22
Rewriting the drive. -
I23
The initialization process has been started
by using the function button and settings
are being initialized.
-
I25
Updating the LinkStation firmware. Do not turn off the LinkStation’s power.
I26
The initialization process has been started
by using Settings and all settings are being
initialized.
Do not turn off the LinkStation’s power.
I27
Checking the USB drive. -
I28
Formatting the USB drive. Do not turn off the LinkStation’s power.
I46
Data migration or conversion (RAID
migration) is in progress.
Do not turn off the LinkStation’s power.
I47
Data migration or conversion (RAID
migration) is in progress.
Do not turn off the LinkStation’s power.