Operation Manual

Using your LinkStation
LinkStation User Manual 100
To save energy, you can specify times to put the LinkStation into standby mode, where the hard
disk and LED lights are turned o. The sleep timer only works when the LinkStation's Power Mode
Switch is ON. This feature cannot be used when it is set to AUTO.
Note:
• If you are using LS-QVL or LS-AVL LinkStation models, set the Power Mode Switch to MANUAL.
1
2
• During processing disk check, disk format, and backup jobs or when a backup job is
scheduled before and after 5 minutes of the current time, the LinkStation will not be
proceeded to Standby mode even though the end time has reached.
• If time of the timers are duplicated, the longest interval time is used to operate.
1 Specify a [Timer Interval],[Wake up at] and [Begin
Sleep at].
2 Click [Save] at the bottom of the screen.
Sleep Timer
1 In the Web Admin interface, navigate to [System]
- [Power Management] - [Sleep Timer]
2 Click [Modify Settings].
* You can set up to 3 timers.
* You can set ending time from 0:00 to 27:45.
You can set beginning time from 0:00 to 23:45.
(If the ending time is 24:00 or later, the beginning time can be set from 4:00 to 23:45.)
If 24:00 is equivalent to 0:00 of the next day, and 27:00 is equivalent to 3:00 of the next day.
* You can not set the ending time before or the same time as a beginning time.