Operation Manual

217
Chapter 10 Appendix
Code Description Corrective Action
I43
The TeraStation was started from the
USB initialization device, but the settings
cannot be initialized from this USB
initialization device.
-
I44
Initialization from the USB initialization
device was initiated, but drive 1 was not
detected.
Make sure that drive 1 is present and fully
inserted in its slot.
I45 Initialization failed. -
I46
Data migration or conversion (RAID
migration) is in progress.
Do not turn off the TeraStation’s power.
I47
I48
This TeraStation is ready to become the
failover backup for the main TeraStation.
Press and hold the function button on the
front of the target TeraStation until it stops
beeping to accept failover backup status.
I49
The main TeraStation in the failover
configuration cannot be found.
Make sure that the main TeraStation is on,
working, and connected to the network.
I50 Failover maintenance is in progress. Do not turn off the TeraStation’s power.
I51 Initializing the failover configuration. Do not turn off the TeraStation’s power.
I52 A new firmware version has been released. Update the firmware.
I54 The backup job failed.
Make sure that the backup job is
configured correctly, and that the NAS
is on and not in standby mode. If the
backup job still fails, check the status of
NAS, network, and backup source and
destinations.
If you configured the subfolders’ access
restrictions to be inherited to the backup
destination, disable them or change the
destination.
I55
Authentication during initialization of
settings failed.
Settings can only be restored for the
TeraStation whose settings were originally
saved.
I59 Boot authentication failed.
Open Settings, take note of the displayed
decryption key and forward the key to the
authentication server administrator.
I61 The unit is in drive setup mode.
Recover from drive setup mode by
following the procedure at the “Power LED
Keeps Blinking” section.
I70
There is not enough space to save file
access logs.
Delete unnecessary logs or move them to
another place.
I71
The space is occupied so older logs were
removed.
Delete unnecessary logs or move them to
another place.
Default Settings
Administrator’s Name admin
Password password
Shared Folders
“share”
*
and “info”
**
for both Windows and Mac computers.
*The recycle bin is enabled by default.
**It is a read-only share.