Owners manual

150
Using a Redundant RAID Mode Other Than RAID 0 and TeraStation
Is Off
1 Open the front cover with the key.
2 The failed drive's status LED will be glowing red. Push its unlock button and swing the lock mechanism out.
3 Pull out the drive cartridge and remove it from the TeraStation.
4 Insert the new drive into the empty slot. Slide the drive in with the locking mechanism open. Swing the lock
back down until it clicks into place.
5 Close the front cover.
6 Press the power button on the TeraStation.
7 When the replacement drive is recognized, the status LED will flash red and the I31 information message will
be displayed on the LCD panel.
8 Press the function button on the front of the TeraStation. The TeraStation will beep. If replacing multiple
malfunctioning drives at once, select the replaced drives on Settings and click Recover RAID Array.
9 The TeraStation will start rebuilding the RAID array automatically. It will take about 5 minutes before the I18
message is displayed.
Using RAID 0
Drives in a RAID 0 array do not automatically turn off in the event of a malfunction. Before replacing the failed drive,
shut down the TeraStation.
This section describes the process of replacing a drive with the TeraStation off.
Note: If a drive malfunctions in RAID 0, all data on the RAID array will be lost. All of the settings for the shared
folders (such as access restrictions) are erased after replacing a drive from a RAID 0 array.
1 Open the front cover with the included key.
2 The failed drive's status LED will be blinking red. Push its unlock button and swing the lock mechanism out.
3 Pull out the drive cartridge and remove it from the TeraStation.
4 Insert the new drive (sold separately) into the empty slot. Slide the drive in with the locking mechanism open.
Swing the lock back down until it clicks into place.
5 Close the front cover.
6 When the replacement drive is recognized, the status LED will flash red and the I32 information message will
be displayed on the LCD panel.
Select the RAID array from Storage - RAID in Settings and click Delete RAID Array. In Storage - Drives, click Format
Drive to format the new drive. In Storage - RAID, choose the type of RAID array desired. Enter the confirmation
number and click OK. Create a shared folder before use.