User manual

WHR-HP-GN / WHR-HP-G300N User Manual 26
Chapter 4
Conguration
Theweb-basedcongurationinterfaceletsyouchangeAirStationsettings.Don’tchangethese
settingsunlessyouknowwhatyou’redoing.
Accessing the Web-based Conguration Interface
ToconguretheAirStation’sadvancedsettingsmanually,logintotheweb-basedcongurationinterface
as shown below.
1
2
3
Launchawebbrowser.
EntertheAirStation’sLAN-sideIPaddressintheaddress
eld, and press the enter key.
When this screen appears, enter [root]
(in lower case) for the user name and the
password that you set during initial setup.
Click[OK].
Note: · By default, the password is blank (not set).
· Ifyouforgetyourpassword,holddownthe
Reset button (page 11) to initialize all
settings. The password will then be blank.
Note that all other settings will also revert to
their default values.
Note: · TheAirStation’sdefaultLAN-sideIPaddressdependsonthepositionofthemodeswitch.
 Inroutermode:192.168.11.1
Inbridgemode:192.168.11.100
IftherouterswitchissettoAUTOandtheunitisinbridgemode,thentheAirStation’sIPaddresswas
assignedbyanexternalDHCPserver.
· IfyouchangedtheIPaddressoftheAirStation,thenusethenewIPaddress.