Use and Care Manual

WLSFB INSTRUCTION MANUAL

__ __ __ __ __ __ __ __ __________________

(record your personal 3-8 digit security code) (Wall Safe Serial Number)

COMPLETE & SUBMIT REGISTRATION CARD TO VERIFY OWNERSHIP

KEEP THIS MANUAL AND SALES RECEIPT FOR FUTURE REFERENCE

If you experience a problem or have questions, visit http://www.buffalotools.com or call Customer

Service at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM Central Time. A copy of the

sales receipt is required.

You will use the key to open the safe for the first time. Insert the key and turn it counter

clockwise. Then turn the knob clockwise.

Install 4 (four) AA (1.5V) batteries. IMPORTANT: You must reprogram your 3-8 digit security code

after you change batteries.

The factory set security code is:

1, 5, 9, #.

(You should change the code as soon as possible after opening the safe to insure proper security.)

After you have entered the factory code, you will need to turn the handle clockwise to open the door.

You will have 5 seconds to turn the handle before the locking mechanism is reactivated.

SECURITY NOTE: If you enter the wrong combination 3 times, the safe will automatically lock. You will

then have to use the emergency key to open the unit and disable the Beeping Alarm. (Remove the

battery to disable the beeping alarm.

Key Cover

PAGE 1
WLSFB INSTRUCTION MANUAL __ __ __ __ __ __ __ __ (record your personal 3-8 digit security code) __________________ (Wall Safe Serial Number) COMPLETE & SUBMIT REGISTRATION CARD TO VERIFY OWNERSHIP KEEP THIS MANUAL AND SALES RECEIPT FOR FUTURE REFERENCE If you experience a problem or have questions, visit http://www.buffalotools.com or call Customer Service at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM Central Time. A copy of the sales receipt is required.
PAGE 2
ENTERING YOUR SECURITY CODE To enter your own personal security code, follow the steps listed below. 1. After opening the electronic safe door (with the preset factory code of 1, 5, 9, #), locate the small red button on the inside of the door near the hinge. 2. Press the red button and then release it. You will hear a beep. The yellow light on the faceplate will be activated and will stay on for a period of time that should allow you to enter your code.