Operation Manual

18
of a kettle descaler in order to dissolve these chalky deposits or lime build up. Follow the directions on the
descaler package. By the way BUGATTI suggests the following natural way: if a commercial descaler is not
available, ll the kettle with enough white vinegar to cover by 2 cm the bottom. Bring the vinegar to a boil.
You may need to repeat this several times with cooled vinegar to remove the calcium build up completely.
When the descaling process is complete, empty the kettle and rinse out several times with clean water.
Troubleshooting
If the Vera kettle develops faults or defects or if irregularities are suspected, unplug it immediately.
If you cannot eliminate the fault by following the instructions in this manual, contact Customer Care
at BUGATTI. Repairs carried out incorrectly expose the user to grave danger. No liability is accepted
for damage or injury caused by repairs carried out incorrectly and in such cases warranty rights are
voided.
TROUBLE
The kettle does not work pro-
pely or stops before boiling.
If the water tastes bad.
The kettle is switched on
and after a few seconds it
automatically switches off.
POSSIBLE CAUSE
There is lime scale into the
kettle.
1) Water is in the kettle
for more then 12 hours.
2)The kettle is not well
washed after the descaling
cycle.
The kettle is empty and the
protection system of the re-
sistance is working.
SOLUTION
Make the descaling as for point
b) of the Cleaning and mainte-
nance chapter.
1) We suggest to chan-
ge the residual water af-
ter each boling cycles.
2)Rinse the kettle sufficient
times in order to remove
completely the descaling
product.
Wait approximately 10 mi-
nutes, fill the kettle with
water and switch it on.