Manual

SECTION 2 - OPERATION

2-120

FWD STEERING STOPS

A steering stop is incorporated at each end of the

axle. The stops are adjustable and must be set to

provide a minimum clearance of 38 mm (1-1/2″)

between the tires or, if installed, fenders, and any part

of the tractor with the wheels turned full left and right

with the axle fully oscillated.

NOTE: If your tractor is equipped with optional front

fenders, ensure there is adequate clearance under

all operating conditions. Adjust the steering stops, as

necessary. Fenders will have to be removed for

1524 mm (60

″

) track spacing.

Adjust the steering stops at both ends of the axle to

the same turn angle.

To adjust the steering stop loosen jam nut, 1. Use a

wrench on the end of the threaded stop at, 2, and

thread the stop in or out so it will contact the fixed axle

stop, 3, when there is at least 38 mm (1-1/2”)

clearence between the tire and tractor as previously

described. Lock the jam nut, 1, to maintain the

adjustment.

Adjust the steering stop on the opposite side to the

same turn angle. Check that both stops are adjusted

to provide the specified clearence.

WARNING

Maintain all steering components in a reliable

and satisfactory condition to ensure safe

operation and comply with legal requirements.

179