Manual

SECTION 5 - SPECIFICAT IONS
5-9
2145 2160 2180 2210
CAPACITIES
Main Fuel Tank L 246 246 246 246
(US gal) (65) (65) (65) (65)
Auxiliary Fuel Tank L 170 170 170 170
(US gal) (45) (45) (45) (45)
Total Fuel Capacity L 416 416 416 416
(US gal) (110) (110) (110) (110)
Cooling System L 25 25 26.4 26.4
(US gal) (6.6) (6.6) (7) (7)
Engine Oil (with filter) L 21.0 21.0 21.0 21.0
(US gal) (5.5) (5.5) (5.5) (5.5)
Four Wheel Drive Front Hubs
(amount shown is for one hub only)
L5555
(US qts) (5.3) (5.3) (5.3) (5.3)
Four Wheel Drive Differential Case
L 14.5 14.5 14.5 14.5
(US qts) (15.3) (15.3) (15.3) (15.3)
Transmission/*
Rear Axle/
Hydraulic System
L 117 140 140 140
(US gal) (30.9) (36.9) (36.9) (36.9)
NOTE: When operating remote cylinders, the rear axle oil level will be affected. When topping up the rear
axle to accommodate the oil requirement of remote cylinders, no more than 38 liters (10 US gallons)
should be added to bring the oil level up to the full mark on the dipstick when all rams are fully extended.
Remote cylinders with a total oil capacity of up to 23 liters (6 US gallons) may be connected to the tractor
hydraulic system without adding oil, provided the tractor is being operated on level ground.
*NOTE: Normal oil change capacities may be 19-23 liters (5-6 gallons) less than these factory fill
capacities. This difference is that oil remains in hydraulic tubes, passages and wet areas within the
transmission and rear axle center sections.
LUBRICANTS
Area Specification
Four Wheel Drive Differential All season ag. transmission Hydraulic oil----See NOTE below
Four Wheel Drive Front Hubs All season ag. transmission Hydraulic oil----See NOTE below
Front Wheel Bearings (2 WD) and
Front Hub Swivel Bearings (4 WD) Lithium Base EP High Temperature with moly
Lubrication Fittings Lithium Base EP High Temperature with moly
Transmission/Rear Axle All season agricultural transmission Hydraulic oil----See NOTE below
Engine API CF-4