Manual

SECTION 2 - OPERATION

2-31

EIC PROGRAMMING

OPERATOR CALIBRATION

In order that the modules may correctly calculate and

display work done (area per hour, area accumulated,

etc.) various factors must be entered into the

modules. To enter the set up mode, turn the key-start

switch on and hold down the SET UP/SELECT

switch, 2, for three seconds until a “beep” is heard.

The TPM display will indicate __ __ __ 1, which

means the EIC is in the first of 12 programming and

diagnostic modes. Touching the D IGIT SET switch,

4, Figure 44, will cycle through modes 1 - 12. Mode,

1, is for operator calibrations. Modes 2 - 12, are

discussed in the Service Manual.

To enter Mode 1, hold the SET UP/SELECT switch,

1, for three seconds. The TPM display will show IMP.

WIDTH CAL and a flashing left-hand digit.

When in the set up mode, repeatedly touching the

SET UP/SELECT switch, 1, will cause the modules

to run through the various set up functions in the

following order:

1. Implement width

2. Slip alarm point (option)

3. Service Alert Indicator I

4. Service Alert Indicator II

5. Ground speed calibration

6. Area Preset

7. Fault code display - ON/OFF

8. Three Point Hitch position -- Area Counter