Manual

SECTION 2 - OPERATION

2-36

Area Preset

Normally, area would be reset to zero by holding the

START/STOP switch, 3, down until a “beep” is heard

from the alarm (approximately three seconds) when

in the AREA PRESET calibration mode. However, it

is possible to enter a value other than zero and

measure additional area worked. Area measured

during a previous operation can be entered.

The area preset will appear as a four-digit display, 1,

with the left-hand digit flashing. “AREA,” 8, will also

be displayed in the LCD along with the CAL legend,

2, and FT, 7, or METERS. Use the DIGIT SET, 6, and

DIGIT SELECT, 5, switches, as previously de-

scribed, to change the value to the desired setting or

to zero.

Touch the SET UP/SELECT switch, 4, and the

display will cycle to fault codes, ON/OFF.

FAULT CODES ON/OFF

Fault codes can be displayed during tractor

operation or not displayed to allow full operation of

the TPM.

In the event that a fault occurs within the tractor

electrical circuits, a malfunction warning symbol

“READ YOUR MANUAL,” 1, will flash on and off and

the code will be stored.

The tractor is factory set to display normal TPM

functions and to store fault codes. The “OFF” legend,

3, will be displayed.

To view fault codes as they occur, press the

START/STOP switch, 4. The display w ill show the

“READ YOUR MANUAL” symbol, 1, and the “ON”

legend, 2. Press the START/STOP switch again and

the “READ YOUR MANUAL” legend, 1, and the

“OFF” legend, 3, will be displayed.

When “ON” is displayed, fault codes will appear as

they occur and also be stored in memory. When

“OFF” is displayed, the fault code will be stored in

memory and the “READ YOUR MANUAL” symbol, 1,

will be displayed.