74” Allied Snowblower TABLE OF CONTENTS DESCRIPTION PAGE Warranty................................................................................1 Safety Instructions & Safety Sign Locations......................2 Operating Instructions ..........................................................3 Assembly Instructions ..........................................................4 74” Allied Snowblower Drawings .......................................6 74” Allied Snowblower Parts List ........................
74” Allied Snowblower WARRANTY REGISTRATION AND POLICY Buhler Manufacturing products are warranted for a period of twelve (12) months from original date of purchase, by original purchaser, to be free from defects in material and workmanship under correct, normal agricultural use and proper applications.
74” Allied Snowblower This manual is for 74" snowblowers with an open gear gearbox. When ordering parts, specify model number and serial number. The snowblower is the push type and will mount to a tractor with a 540 rpm PTO. It is supplied with category 1 pins and also bushings, which convert the pins to a category 2. A category 1 Quick Hitch also fits on this snowblower. This 74" wide snowblower comes with a hydraulic chute control as standard equipment. A hand crank chute control is available.
74” Allied Snowblower OPERATING INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 10. 11. 12. 13. Do not operate the blower in the fully raised position. The three-point hitch on some tractors raises high enough to cause the PTO shaft to bind. This can cause damage to the PTO shaft and/or to the hitch and pins. ALERT: PTO shaft angle should not exceed 20 degrees for optimum performance and life. Damage may occur to PTO and/or snowblower if angle becomes more extreme.
74” Allied Snowblower ASSEMBLY INSTRUCTIONS 1. Turn the bottom tube weldments (#9) as shown in drawing and slide them into the sleeve welded to the main body. These tubes have holes for two positions. The correct position for each individual tractor will be determined when mounting the snowblower on the tractor. These tubes are connected to the tractor with a ¾” x 4 ¼” pin (#96) and a hairpin clip (#104). 2.
74” Allied Snowblower ASSEMBLY INSTRUCTIONS – cont’d. 7. Mounting blower on tractor: a) Mount the blower on a tractor with a category 1 or category 2 hitch. b) Using tape or bright colored marking pen, mark on the outer shields the position where the shaft is completely pushed together and the position where you have a 4" overlap. Watch these marks when moving the blower through all possible operating angles to see that the PTO shaft stays within this range.
4” Allied Snowblower - 6-
74” Allied Snowblower - 7-
74” Allied Snowblower WHEN ORDERING PARTS Always give your dealer the Model, Color and Serial Number of your machine to assist him in ordering and obtaining the correct parts. Use the exploded view and tabular listing of the area of interest to exactly identify the required part.
74” Allied Snowblower 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 64 65 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 901940 965413A 936402 81527 84498 968627 967260 965822 965447 965414 965415A 907218A 965834A 84111 984077 965825 965826A 965827 965844A 86171 965917 961675A 84289 965416A 907820 965832 9812433 907674 967164 81549 81569 81568 965968A 960135A 9812432 900712 965410A 81523 81545 81544 812364 988999 907221A 965646 903523 5/16'' x 1 1/4'' Key Drive Shaft 1 1/4
74” Allied Snowblower 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 961012 961658 961876 902407 9812487 967110 9812439 967135 9812444 9812443 907250A 907315A 907316A 905821 84336 81701 81700 965808A 967361A 966527 811826 12779 #16 Hair Pin Clip 1/4'' Cable Clamp 1/2'' x 1 1/2'' Clevis Pin (pl) Skid Plate Weldment 1 1/4'' x 10ga Narrow Rim Washer (pl) 1 1/4'' x 14ga Narrow Rim Washer (pl) 1 1/4'' x 18ga Narrow Rim Washer (pl) 1 1/2'' x 10ga Narrow Rim Washer (pl) 1 1/2'' x 14ga
74” Allied Snowblower ALLIED SNOWBLOWER PTO - 11 -
74” Allied Snowblower SNOWBLOWER PTO (STANDARD) Item # Part # 1 2 F842 936263 936264 936277 936199 3 936249 4 903296 903297 812362 936025 906504 936270 936319 936272 936273 936274 936269 81627 812364 5 6 7 8 9 10 11 12 13 14 Description Shaft Complete Tractor Half of PTO (Shear) Implement Half of PTO (Clamp Yoke) Shear Assembly Safety Slide Lock Repair Kit (Collar, Spring, Ret.
74” Allied Snowblower SNOWBLOWER PTO (OPTIONAL LONG) Item # Part # Description 1 2 F844 936285 936280 936277 936199 3 936249 Shaft Complete Tractor Half of PTO (Shear) Implement Half of PTO (Clamp Yoke) Shear Assembly Safety Slide Lock Repair Kit (Collar, Spring, Ret.
74” Allied Snowblower 1.75 X 5 CYLINDER ASSEMBLY Item # 1 2 3 Part # Description 24930 115367 112104 X2669 Cyl Complete Tube Weldt Shaft Weldt 1.0 Dia Seal Kit 3.5 x 8 CYLINDER ASSEMBLY Item # 1 2 3 Part # Description 24803 24804 113934 X2098 Cyl Complete Tube Weldt Piston Rod 1.
74” Allied Snowblower 74” ALLIED SNOWBLOWER BUNDLES QUANTITY BUNDLE NO.
