Specifications

43
Maintenance - 25 Series Rotary Tiller
LUBRICATION
Recommendations
Always use a good quality multi-purpose / lithium base
grease when lubricating the equipment.
• Always use a hand-held grease gun.
• Clean fitting before greasing, to avoid injecting dirt
and grit.
• Replace and repair broken fittings immediately.
• If fittings will not take grease, remove and clean
thoroughly. Replace fitting if necessary.
Locations
Lubricate the following grease locations EVERY 8
HOURS:
NOTE: The following images may not show your
exact PTO driveline but the procedure is
correct.
Figure 18
Apply two - three pumps of grease to the cross and
bearings (Item 1) [Figure 18] on the PTO driveline.
Do not over-grease bearings. Greasing too often can
damage seals and lead to premature bearing failure.
Fluid such as engine oil, hydraulic fluid, coolants,
grease, etc. must be disposed of in an
environmentally safe manner. Some regulations
require that certain spills and leaks on the ground
must be cleaned in a specific manner. See local,
state and federal regulations for the correct
disposal.
B-0002
1
1
2-3