Specifications

44
Maintenance - 25 Series Rotary Tiller
Lubricate the following grease locations EVERY 20
HOURS:
NOTE: The following images may not show your
exact PTO driveline as it appears but the
procedure is correct.
Figure 19
Apply two pumps of grease to the guard bushings (Item
1) [Figure 19].
Apply eight - ten pumps of grease to the telescoping
member (Item 2) [Figure 19].
Figure 20
Apply two pumps of grease to the slip clutch (Item 1) and
PTO quick disconnect (Item 2) [Figure 20].
Lubricate the following grease locations EVERY 40
HOURS:
Figure 21
Apply two pumps of grease to the chain case drive
bearing (Item 1) [Figure 21].
Figure 22
Remove the side plug (Item 1) [Figure 22] and check
gear box oil level. The oil level should be at the bottom of
the plug opening.
NOTE: Add 85W-90 gear oil if level is low.
If the oil level is low, remove the top plug (Item 2) [Figure
22]. Add oil until the oil starts to run out of the side plug
opening. Install plugs.
NOTE: If oil level is low look for signs of a leak and
repair as necessary.
B-0002
1
1
2
2
1
8-10
2
B-0215
2
1
2
B-0231
1
2
2
B-0232
1
2