Specifications

Maintenance - 25 Series Rotary Tiller

Figure 27

Locate the drain plug (Item 1) [Figure 27] under the

gearbox. Remove the plug and drain the oil into a

collection container.

Once the oil is drained, install the drain plug.

Figure 28

Remove the fill plug (Item 1) [Figure 28].

Remove the plug (Item 2) [Figure 28] on the side of the

gearbox.

Add one qt. (0.85 l) of 85W-140 to the gearbox or until

the oil begins to flow out of the hole on the side of the

gearbox.

Install the plug (Item 2) [Figure 28] on the side of the

gearbox.

Install the fill plug (Item 1) [Figure 28].

SHEAR PIN

Shear Pin Replacement (If Equipped)

Park the tractor and implement on a flat level surface.

Fully lower the rotary tiller.

Stop the engine and leave the operator’s position. (See

“Leaving The Operator’s Position” on page 25.) Make

sure the PTO driveline and all rotating components have

come to a complete stop before leaving the operator’s

position.

Disconnect the PTO driveline.

Carefully remove remaining shear bolt using a hammer

and punch if necessary. Be careful not to enlarge the

holes.

Install the new shear bolt and tighten. (6 mm & 40 mm,

Grade 5)

B-0248

B-0232