Owner's Manual
To
Unlock
the System After
a
Power
Loss
When battery power
is
reapplied to a secured radio, the
radio won’t turn on and “LOC” will appear on the
display. Enter your secret code as follows; pause no
more than
15
seconds between steps.
1.
Turn the ignition on. (Radio off.)
2.
Press the
SET
button. The display
will
show
“000.”
3.
Enter the
six
digits
of
your code following steps
6-9
on the preceding. The display will show the numbers
as
entered.
4.
Press the lower (BAND) knob and SEC appears,
then the time, indicating that the disabling sequence
was successful.
Disabling the Anti-Theft System:
1.
2.
3.
4.
5.
6.
Press
the
I
and
4
buttons together for five seconds with
ignition on and radio power off. The display will show
“SEC,”
indicating the unit is
in
the secure mode.
Press the
SET
button. The display will show
“OOO.”
Enter
the
first three digits
of
your code following
step
6
and 7of the preceding paragraphs. The display
will
show the numbers
as
entered.
Press the lower (BAND) knob. The radio will
display
“000.”
Enter the second three digits
of
the code. The display
will show
the
numbers as entered.
Press the lower (BAND) knob.
If
the display shows
numbers matched the user-selected code or
the
factory back-up code) and
the
unit
is
in
the
UNSECURED mode. If
the
display shows “SEC,”
the disabling sequence was unsuccessful and the
numbers did
not
match either of the codes and
the
unit
will remain
in
the SECURED mode.
“---
,
”
the disabling sequence was successful (the
135